![]() The IP of the corresponding eth0 communication on Jetson is 192.168.138. If it is a Windows version with its own network interface, the configuration will be simpler. It should be noted that since the configuration of MAC in the network is actually the network transferred out by USB, even if the IP address is configured as a fixed 192.168.138.1 in the way of manual IPv4, the IP address of eth0 corresponding to Jetson is actually 192.168.3.6. Ping Baidu after success, you can access the Internet, no problem. If you want to continue, just fill in yes. The user name IP of SSH Ubuntu will tell you for the first time that the permissions there are not enough. Open the terminal on the Mac and log in directly via SSH. As shown in the figure below, it is turned on. Sudo service SSH start starts the SSH service, and sudo PS – e | grep SSH ා checks whether the SSH service starts. If the Ubuntu of Jetson nano does not have SSH installed, you need to execute sudo apt get install openssh server to install SSH. If there is a display, you can connect it to a Baidu whisper, or use the terminal SSH access test first. After each reconnection, if 192.168.3.6 fails (MAC is restarted, fixed IP is changed, Jetson has connected to other computers, etc.), it means that the DHCP of Jetson dynamically allocates a new IP address, and the terminal re inputs arp-a to obtain a new IP address of Jetson.Īt this point, the network connection between MAC and Jetson is realized, and Jetson can also access the Internet. Write down the IP address, which will be used to establish the connection and FTP later. As shown in the figure below, IP of type must be Jetson nano. ![]() Then the terminal input arp-a to get the IP address of Jetson is 192.168.3.6. In fact, the network sharing setting or not setting DHCP has no impact, as long as both sides can ping the general problem is not big. It is difficult to set the static IP setting without a display. Generally speaking, the default mode of Ubuntu network card is DHCP. In this blog post, DHCP is used for modification, and then the address of apple computer is found through ifconfig, and then the static IP is set in / etc / network / interfaces of raspberry pie to ensure that the static IP and the IP from ifconfig are in the same network segment. The solution I adopt is to share WiFi network port. My notebook is Mac, no network port, using the jet connection of type-C to RJ45 port. network communication between laptop and Jetsonįirst, connect directly to PC and jetson nano. Based on the principle of saving money, simplicity and efficiency, a LAN between laptop and Jetson nano is set up with a single network cable to realize VNC viewer’s access to Ubuntu 18.04 unity desktop, FTP installation, FTP user creation and FTP file transmission. However, there is a lack of a display on hand. ![]() Recently, we started to install Ubuntu 18.04, a Jetson nano from NVIDIA.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |